Filter
Top Products
4
Inserting the Batteries
The labelmaker uses four high-capacity AA alkaline batteries.
To insert the batteries
1. Remove the battery compartment
cover. See Figure 2.
2. Insert the batteries following the
polarity markings (+ and –).
3. Replace the cover.
Ç Remove the batteries if the
labelmaker will not be used for a long
period of time.
Figure 2
Connecting the Optional Power Adapter
An optional 9 Volt,1.5 A power adapter can also be used to power
the labelmaker. Connecting the AC adapter to the labelmaker
disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top of
the labelmaker.
2. Plug the other end of the power adapter into a power outlet.
LT Momentum AUS.indd 4 19-03-2007 09:12:48