Filter
Top Products
3
About Your New Printer
With your new DYMO RhinoPRO
™
3000 label
printer, you can create a wide variety of high-
quality, self-adhesive labels. You can choose to
print your labels in many different sizes and styles.
The printer uses DYMO RhinoPRO Industrial label
cassettes in widths of 3/8” (9 mm), or 1/2” (12 mm).
RhinoPRO label cassettes are also available in a
wide range of materials.
Visit www.dymo.com/industrial for information on
obtaining tapes and accessories for your printer.
Warranty Registration
Please complete the warranty registration card and
return it to the appropriate address, or you can
register online at www.dymo.com/industrial.
Getting Started
Follow the instructions in this section to print your
first label.
Power Supply
The printer is powered by standard batteries or an
AC power adapter. To save power, the printer will
automatically turn off after five minutes of inactivity.
Inserting the Batteries
The printer uses six 1.5 volt AA alkaline batteries.
To insert the batteries
1. Press the thumb latch on the bottom of the
printer to open the battery compartment door.
See Figure 2.
Figure 2
2. Insert the batteries following the polarity
markings (+ and –).
3. Close the battery compartment door.
Remove the batteries if the printer will not be
used for a long period of time.
Connecting the AC Adapter
You can also use an optional AC power adapter to
power the printer. Connecting the AC adapter
disconnects the batteries as a power source.
To connect the AC adapter
1. Plug the power adapter into the power connector
on the top of the printer.
Figure 3
2. Plug the other end of the power adapter into a
power outlet.
Press thumb
latch