Filter
Top Products
Data Power Solutions Quick Start Guide
10
Copyright © 2006-2009 Eaton Corporation. All Rights Reserved.
10640205 February 2009
Batteries (if applicable)
• Always install the batteries according to the relevant battery manufacturer’s instructions.
• Batteries are powerful sources of energy and present a potential electrical shock and energy hazard. The
energy hazard is always present, even if the batteries are not connected. Avoid short circuiting terminals of
opposite polarity.
• Batteries are heavy, awkward to handle and can cause personal injury. To prevent back injury, use correct
lifting and bending techniques when moving batteries. If the batteries are too heavy to move, request
assistance.
• Remove or cover rings, wristwatch and other metal jewelry that might be exposed to battery terminals, before
installing batteries.
• Do not wear synthetic clothing when installing batteries.
• Always use insulated tools.
• Only use a clean soft damp cloth for cleaning the batteries. Do not use cleaning detergents or chemicals.
• When unpacking the batteries inspect them carefully for leaks, corrosion and possible damage. Report any
damage or other battery related problems immediately to your battery supplier.
• Do not remove the factory-fitted transit insulation covers from the batteries until access to the battery
terminals is required.
• Do not place tools, loose cables or metal objects (such as interconnecting bars) on top of batteries.
• Do not drop tools, loose cables or metal objects onto intercell connections or terminals of opposite polarity.
• Only terminate cables and interconnecting bars after confirming that the termination will not create a short
circuit.
• Always tighten the battery terminal bolts according to the battery manufacturer’s specification. Failing to do
so can cause erratic battery performance, possible damage to the battery, and/or personal injury.
• Always ensure that any shrouding supplied with the batteries is correctly fitted to cable connectors.
Rectifiers
• To reduce the risk of electric shock and maintain optimum system cooling, always cover empty rectifier
slots with blanking panels (Part Number: IPN 621-05722-63A).
• To avoid electrical shock, do not place hands inside the rectifier shelf.
• Rectifier cases may exceed 100ºC (212ºF), especially after prolonged operation. Use suitable gloves to
remove the hot rectifier.
• Do not attempt to disassemble rectifiers. Return them, (in their original packaging) along with the
completed Equipment Incident Report, to your local Eaton dc product representative for replacement or
repair.
整流器
• 为了降低触电风险并保持系统最佳冷却，始终应把整流器盲板（编号：IPN 621-05722-63A）
安装到未安装整流器的空位上。
• 为了避免触电，不要把手伸到整流器架内。
• 整流器外壳温度可能会超过100ºC，特别是在长期运行之后。拆取发热整流器时， 应戴上合适的手套。
• 不要尝试拆卸整流器。如果需要更换或修理，应把整流器按照原样打包，
连同完整的设备故障报告一起，返回给当地Eaton直流产品办事处。