Filter
Top Products
53
6.2 Enable Print Server’s TCP/IP Support
The default configuration of the print server is with TCP/IP
support enabled. Anyway, you can configure the print
server to enable TCP/IP support using the configuration
program.
6.3 Setup Print Server’s IP Address
The print server must have a unique IP address in order to
be recognized by the network.
You can set up the IP address on the various Unix
systems using any one of the following methods:
1. DHCP (Dynamic Host Configuration Protocol)
2. BOOTP (Bootstrap Protocol)
The print server will use the last three methods to obtain
its IP address automatically if its IP address is configured
as Auto (0.0.0.0).
6.3.1 DHCP
There are many Unix systems that support DHCP protocol,
and the procedures to configure the DHCP server
database are different. This manual does not describe the
DHCP server configuration on the Unix systems. It is
highly recommended that the DHCP server should be
located on the same network as the print server.