Filter
Top Products
z When you switch one PC port to another, please set the scan time for 5 sec at least. .
Normally, it takes one or tow seconds for the VGA monitor to change from one
resolution mode to another. So, the scan time is not recommended to be less than 5
seconds.
7. The power switch is off, but the switch still works fine or power adapter is unplugged
from the switch, but the switch still works fine.
KVM Switch unit draws the power source from power adapter and all PC’s PS/2 port.
Some PC’s PS/2 port can support enough power for the switch, but some PC’s PS/2
port ( like laptop, notebook computer…etc.) is unable to supply enough power for the
switch. In order to make sure the system can work steadily, please do not set power
switch as off state or remove the power adapter from the switch.
Although the PCs connected to KVM Switch unit are able to support enough power
to the stand alone switch, KVM Switch unit still needs a power adapter for daisy
chain more banks.
8. If you forget the “ password ” you typed, please contact your supplier.
9. CAT5 Console Receiver power LED is not ON, to make sure power adapter is
connected to KVM CAT5 receiver.
10. No video signal is displayed on the remote monitor.
a. It might happen because VGA cables & connecter and CAT5 cable &
connector is loosed or disconnected or VGA cable was not attached to
computer during boot up process.
b. Or power adapter is not connected to receiver.
11. When video signal is foggy or un-cleared on the screen, please check if VGA
connector is connected properly, or if the VGA resolution is too high for the length of
cable being used. If the problem happened at VGA resolution, please shorten the
CAT5 cable length or reduce VGA resolution. It is highly recommended to use
“optimal CAT5 cable length “to get the best video quality and avoid wasting
unnecessary CAT5 cable.
VGA resolution is up to 1280X1024 and CAT5
cable length could up to 500 feet approximately.
CERTIFICATIONS
FCC
This equipment has been tested and found to comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received. Including interference that may cause undesired
operation.