Filter
Top Products
25
Connecting to a Computer
Connecting to a computer (INPUT 5)
• Before connecting the cable, switch the digital input type switch to “PC”.
RGB output terminal
INPUT 5 terminal
RGB cable (commercially available)
DVI to 15-pin D-sub adaptor
(commercially available)
Computer
4
3
2
Switch to “PC”
1
Note
•
Refer to “Computer Compatibility Chart” on page 61 for a list of computer signals compatible with the projector. Use
with computer signals other than those listed may cause some of the functions not to work.
•
When connecting the projector to a computer in this way, select “RGB” for “Signal Type” on the OSD menu or press
on the remote control. (See page 48.)
•
A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest EIKI Autho-
rized Dealer or Service Center.
•
Depending on the computer you are using, an image may not be projected unless the signal output setting of the
computer is switched to the external output. Refer to the owner’s manual of the computer for switching the computer
signal output settings.
When connecting a computer, ensure that it is the last device to be turned on after all the
connections are made.
EIP-1500T_E_P19_27.p65 5/22/05, 5:49 PM25