Filter
Top Products
Installation Drawings 33
Figure 14 Outline Drawing, Battery Power Pack, 25-Inch Cabinet
1/22/03
UBC11001
DATE
FILE NAME: Batts\UBC11001-03
COLUMBUS, OHIO 43229
1050 DEARBORN DRIVE,
REV. NO.
DWG. NO.
V CARMONA
REF. DWG.
CHK BY
DRAWN BY
3
OUTLINE DRAWING
25" BATTERY CABINET
NPOWER
DETAIL FOR DC BUS BARS
FRONT VIEW
WITH DOOR
SIDE VIEW
WITH COVER REMOVED
FRONT VIEW
WITH DOOR AND
BARRIER REMOVED
WITH SIDE PANEL REMOVED. SIDE PANELS ARE
BOLTED TOGETHER.
REMOVED BETWEEN ADJACENT UNITS WHICH ARE
14. REFER TO DETAIL A FOR DIMENSION TO FRAME
MOUNTING HOLES FROM UNDERNEATH UNIT BASE.
MOUNTING BOLTS MUST BE THREADED INTO UNIT
SUPPORTED UNDER ALL CASTERS.
IS USED THE WEIGHT OF THE UNIT MUST BE
ANCHORING OR FLOORSTAND. NOTE, IF FLOORSTAND
12. THREADED MOUNTING HOLES USED FOR SEISMIC
THREADED 12MM INSERT IS APPROX. 3/4" DEEP.
BY (2) 10 GA. (.135") GALVANIZED STEEL. THE
13. EACH MOUNTING LOCATION IS SUPPORTED
1. ALL DIMENSIONS ARE IN INCHES.
2. MIN CLEARANCE 36 INCHES IN FRONT, 12 INCHES
3. KEEP CABINET WITHIN 15° OF VERTICAL WHILE
4. EXTERIOR CABLE ENTRY AVAILABLE THROUGH
REMOVABLE TOP ACCESS PLATES. REMOVE, PUNCH
TO SUIT CONDUIT SIZE, AND REPLACE.
5. CONTROL WIRING AND POWER WIRING MUST BE RUN
6. ALUMINUM AND COPPER CLAD ALUMINUM CABLES ARE
7. ALL WIRING IS TO BE IN ACCORDANCE WITH
NATIONAL AND LOCAL ELECTRICAL CODES.
8. RECOMMENDED OPERATING TEMPERATURE RANGE:
10. UNIT BOTTOM IS STRUCTURALLY ADEQUATE FOR
11. APPROX WEIGHT OF CABINET IS 1500 TO 3000 LBS.
MAX DOOR SWING 120°
CONDUIT ENTRY
6.5 x 6.0
TOP ONLY
2 PLACES
BIB
BOARD
ACCESS
TOP VIEW
BATTERY SERVICE ACCESS
12MM THREADED
MOUNTING HOLE
BOTTOM VIEW
BATTERIES
DC BUS BARS
NOTE:
(10)TRAY SHOWN.
(8) TRAY FOR FR200 BATTERY
ASSY AND SMALLER
CIRCUIT
BREAKER
CIRCUIT
BREAKER
MOTOR
OPERATOR
OPTIONAL
CASTER
FRONT
DETAIL A
SIDE ACCESS
CONTROL AND
APPROX AREA
(BOTH SIDES)
REAR OF UNIT SHOWN
WITHOUT SIDE PANEL
DC BUS BARS
4.6 x 2.2
POWER WIRE
68°F-77°F (20°C-25°C).
9. COLOR - IBM OFF WHITE.
FORKLIFT HANDLING.
LEVELER
2.72
AT TOP FOR AIR EXHAUST.
IN SEPARATE CONDUIT.
NOT RECOMMENDED.
HANDLING.
NOTES:
CENTER
GRAVITY
CENTER
GRAVITY
12mm DIA. THREADED
MOUNTING HOLE (4) TYP.
(SEE NOTES 12 & 13)
(SEE DETAIL A)
15. "BEFORE SLIDING OUT BATTERIES ON BATTERY TRAY"
SECURE (2) SUPPORT BRACKETS TO THE SUPPORT TRAY
POSITION SUPPORT TRAY AND ATTACH TO CABINET. THEN
SUPPORT TRAY &
SUPPORT BRACKET
(SEE NOTE 15)
CENTERS
CASTER CENTERS
12MM
12MM CENTERS
CENTERS
AND TO THE CABINET. REFER TO THE APPROPRIATE
USERS MANUAL FOR FURTHER DESCRIPTION & DETAILS.