Filter
Top Products
1592010860 XWEB5000 stp GB r1.1 2012.06.22.doc XWEB5000 6/48
2. INSTALLATION
Do not open XWEB. Its opening makes its warranty invalid. However, to install
XWEB you need:
One blade and one cross screwdrivers
Mouse PS2
Keyboard PS2
Standard VGA screen (no high definition/HDMI)
To install XWEB, please refer to the picture below which represents the back of
XWEB. Apply then following procedure:
1. XWEB has grounding receptacle. Verify the implant in which it will be connected to
adopt electrical ground protection;
2. Fix XWEB at its operating position. In
case of placement on a table insert
provided rubber feet. In case of usage
on rack, use provided brackets and
screws.
3. To connect XWEB to the electrical
network use provided power supply
cable(1). Power supply cable shall
always be easily accessible by an
operator. Do not power the system
on.
4. Connect RS485 network, relays and
digital input (3).
5. Connect to telephonic line network
and/or to LAN (4).
6. Connect keyboard and mouse with
provided cable (5).
7. Connect monitor (5).
8. Connect printer to USB or parallel
receptacles.
9. Connect optional external modem (7).
Its cable shall be maximum 10 meters
long.
10. Power the system on, pressing and
releasing button (2).
Connect XWEB to the electrical network with
provided cord before any servicing operation.
This is for personnel and system safeguard.
Operators shall avoid direct passage of
electronic devices that can cause electric
discharges and damage the device itself;
Power supply voltage shall not differ from the
one required. It can seriously damage the
system;
Mistaken connections can be dangerous and
compromises operators’ safety. Moreover they
can damage the system and/or other connected
instruments.
Adopt one or more external isolator switches to
separate devices to power supply network. They
shall easily accessible.
Do not use XWEB in environments with
inflammable gas.
Do not modify XWEB in any way.