Filter
Top Products
Version 1.02
22
Chapter 3. Network Topologies
This chapter describes several main types of installations implemented by
using the Outdoor Wireless System commonly. This is by no means
intended to be an exhaustive list of all possible configurations, but rather
shows examples of some of the more common implementations. The
Wireless client bridge can only be configured into Wireless Client
Router/Bridge to accomplish the broadband wireless point-to-point, point-
to-multipoint systems with Central Bridge as the figure shown below.
The Wireless client bridge performs in either router or bridge mode. In a
Point-to-Multipoint topology, all communication between network systems is
done through a centralized agent. Among the Outdoor Wireless
Router/Bridge products, the centralized agent is Central Router or Central
Bridge and the individual network notes may be Wireless Client Router or
Bridge .
To show the available Point-to-Multipoint topologies, the following examples
are provided.
1. Wireless Client Bridge-to-Central Wireless Bridge
2. Wireless Client Router-to-Central Wireless Bridge
3. Wireless Client Bridge-to-Central Wireless Router
4. Wireless Client Router-to-Central Wireless Router
Version 1.02
23
3.1 Wireless Client Bridge-to-Central Wireless
Bridge
Step 1 Set the Central Outdoor Unit
*1
(hereinafter, “COU”) to perform a
bridge (bridge IP address: 192.168.2.1).
Step 2 Set Wireless parameters on COU: Channel (1) and SSID
(wireless)
Step 3 Set the Remote Outdoor Unit
*2
(hereinafter, “ROU”) to perform a
bridge (bridge IP address: 192.168.2.2).
Step 4 Set Wireless parameters on ROU: Channel (1) and SSID
(wireless), and these parameters must be the same with COU.
Step 5 Left side subnet is transparent to the right side.
Step 6 DHCP server assign IP address to PC1 and PC2
Remarks:
*1 COU refers to Outdoor Wireless Router Bridge
*2 Both and Wireless client bridge could function the role of ROU