Filter
Top Products
Version 1.02
14
IP Use MAC Addr.
You can choice Enable or Disable. If you choice Enable , it will set IP =
10.X.X.X that used to last 3 MAC Address ID.
For example :
MAC Addr = 00:47:55:43:43:49 => IP = 10.67.67.73(43hex=67decimal)
If you choice Disable you need setting Bridge IP Address Information.
Bridge IP Address
Use this setting to assign or change the Wireless client bridge IP address.
Bridge Subnet Mask
Enter an IP subnet mask to identify the sub network so the IP address can
be recognized on the LAN.
Default Gateway IP Address
Enter the default Gateway IP Address, and click FINISH at the bottom of
this page to complete the modification of this page.
2.4.5 Set Wireless Encryption for Wireless Interface
The Wireless client bridge supports 64-bit and 128-bit WEP encryption.
For 64-bit WEP encryption, an encryption key is 10 hexadecimal characters
(0-9 and A-F) or 5 ASCII characters.
For 128-bit WEP encryption, an encryption key is 26 hexadecimal
characters or 13 ASCII characters.
Modify the WEP encryption parameters on the web page “/General
Config/Woreless/”. Enter 1~15 characters into the WEP Key field, and
click KeyGen to generate the WEP64 or WEP128 key patterns.
Version 1.02
15
2.4.6 Change Supervisor Account & Password
Enter the Utility > Administration page. The figure below shows the
Utility/ Administration page.
Supervisor Account
Change the supervisor’s user name and password in the Supervisor
Account field, and click FINISH to take effect on the previous configuration
changes.
Apply the New Settings
Step 1 Enter the Utility > Administration page, select the Save then
Restart to apply the new configuration settings.
Step 2 Click FINISH to take effect on the previous configuration changes.
Hint: It takes about 10 seconds, to complete the restart process.