Filter
Top Products
16 CHAPTER 2: INSTALLING THE ETHERNET ADAPTER
Connecting to an
Ethernet Device
The Ethernet Adapter is designed to be connected to an Ethernet client
device such as a hub, computer, or printer.
CAUTION:
To avoid the possibility of a transmission loop situation between
the Ethernet Adapter and an access point, which could disrupt network
operation, do not connect a Ethernet Adapter that is set in Wireless Client
(Infrastructure) mode directly to the LAN (for example, through a wall port or
through a hub that is connected directly to the LAN).
VORSICHT: Um eine Übertragungsschleife zwischen dem
Ethernet-Adapter und einem Access Point zu verhindern, die den
Netzwerkbetrieb stören könnte, darf ein im Modus Wireless Client
(Infrastructure) (Drahtloser Client [Infrastruktur]) eingerichteter
Ethernet-Adapter nicht direkt mit dem LAN verbunden werden (z. B. über
eine Wandbuchse oder über einen direkt mit dem LAN verbundenen Hub).
About the Client List The Ethernet Adapter supports up to 16 specific Ethernet client devices. It
uses a client list of MAC addresses to keep track of specific devices that
have been connected.
After 16 different devices have been connected, the client list is full, and
you must clear it before the next new device can associate with the
network through the Ethernet Adapter.
To clear the list, you must access the Ethernet Adapter’s Configuration
Management System. Details are in “Clearing the Ethernet Client List” on
page 49.