Filter
Top Products
Local Management Screen Elements
1-4 Introduction
You can also access Local Management using a Telnet connection through one of the network
ports of the SmartSwitch device.
1.4 LOCAL MANAGEMENT SCREEN ELEMENTS
There are six types of screens used in Local Management: password, menu, statistics,
configuration, status, and warning screens. Each type of screen can consist of one to five basic
elements, or fields. Figure 1-1 shows an example of the fields in a screen. A description of each
field follows the figure.
Figure 1-1 Example of a Local Management Screen
NOTE: For details on the setup parameters for the console, how to connect a console
to the SmartSwitch, or how to make a telnet connection, refer to Chapter 2.
Firmware Revision: XX.XX.XX
General Configuration
30691_01
BOOTPROM Revision: XX.XX.XX
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Device Date:
Device Time:
Screen Refresh Time:
Screen Lockout Time:
Clear NVRAM [NO]
Device Uptime XX D XX H XX M
Device Type: xxxxx-xx
IP Fragmentation [ENABLED]
Operational Mode: [802.1Q SWITCHING]
Event Message Field
Display Field
Input Fields
Selection Field
Command Fields
Display Fields
xxxxx-xx LOCAL MANAGEMENT
Event Message Line
RETURNSAVE
10/11/97
14:23:00
30 sec.
15 min.
EXIT
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
See
Note
Note: This shows the location of the cut away that is used in most of the screen graphics
in this document. The top portion of the screen is cut away to eliminate repeating the same
information in each graphic.The screen title is contained in its figure title.