Filter
Top Products
Configuration 29
HP289
5.1 Configuring the Setup Parameters
Step Display Description Text
Ref
1 CAL Setup Program Parameters
BATCH Set Batch Parameters 5.2
OPTION Options (if installed) 5.3
TEST Check Input Signals 5.4
END Exit to normal operation
The following steps are displayed when CAL is selected.
2 RESTOT Reset all totals to zero.
To clear all totals (resettable and
accumulated) press the BATCH SET key
once.
3 SCALE Scaling Factor.
Fact Enter the Scaling factor (K-factor) of the
flowmeter.
3.3.1
4 F dPt Number of decimal points with which the Rate
is to be displayed between 0 to 0000.
5 t.base The Timebase with which the Rate is
calculated must be entered as:
3.2.1
60secs units/min
hours units/hour
days units/day
secs units/second
6 FILTER The filter constant for filtering the rate display. 3.3.2
1 No filtering.
to
99 Very heavy filtering.
7 TOTCON A division factor to convert the totals to
different units from those used for rate (e.g.,
gallons/min and barrels).
3.30
1 Rate and totals have the same engineering
units.
x.xxxx Other factors can be programmed between
0.01 and 2000.
8 t.dPt Number of decimal points with which the
resettable total is displayed between 0 to 00.