Filter
Top Products
EPSON Perfection 3200 Series
11/02 EPSON Perfection 3200 Series - 3
Using the Transparency Unit
To use the transparency unit, remove the reflective document
mat by grasping the top of the mat and sliding it up gently, as
shown.
Make sure the cable for the tranparency unit is plugged into the
round connector. If not, turn off the scanner, then connect the
cable as shown. You may need to raise the scanner cover and
twist the cable to insert it.
Using Film Holders
Film has two sides, a shiny base side and a dull emulsion side.
The base side of the film has the film maker’s name and film ID
numbers printed on it. Place the shiny base side down.
To scan 35-mm film strips, 4 × 5-inch film, or 120/220 (6 × 9-
cm) film, place the film in the correct holder:
Place the holder with the film onto the scanner. Make sure the
white triangle on the holder points to the upper-right corner of
the scanner’s document table.
remove mat
by sliding it up
transparency unit
make sure that
the arrow faces
up
35-mm strips
4 × 5-inch and
120/220 (6 × 9-cm)
film