Filter
Top Products
EPSON PowerLite 54c/74c Projector
12 - EPSON PowerLite 54c/74c Projector 10/03
2. Turn the projector upside-down, as shown below.
To clean the filter, EPSON recommends using a small
vacuum cleaner designed for computers and other office
equipment. If you don’t have one, gently clean the filter
using a very soft brush (such as an artist’s camel-hair brush).
If the dirt is difficult to remove or if the filter is torn, replace
it. Contact your dealer or call EPSON at (800) 873-7766 to
obtain a new one. The air filter set (part number
V13H134A05) contains five filters. In Canada, please call
(800) 463-7766 to locate a dealer.
Note
When you get a replacement lamp for your projector, a new air
filter is included. You should replace the filter when you replace
the lamp.
3. If you need to replace the filter, lift the tab on the filter cover
and pull it upward to remove it.
4. Remove the filter.
5. Install the new filter as shown below.
6. Replace the filter cover by inserting the tabs and then
pressing down the other end until it clicks into place.
Replacing the Lamp
The projection lamp typically lasts for about 2000 hours of use
(in High brightness mode) or 3000 hours (in Low brightness
mode). It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The warning light is flashing red at 0.5-second
intervals.
❏ The message
Lamp Replace appears on the screen when the
lamp comes on. To maintain projector brightness and image
quality, replace the lamp as soon as possible.
Note
You can check how many hours the lamp has been used in the
About menu.
Contact your dealer or call EPSON at (800) 873-7766 in the
United States for a replacement lamp. Request part number
V13H010L27. In Canada, please call (800) 463-7766 to locate a
dealer.