Filter
Top Products
EPSON Stylus PHOTO 810/820/830 Revision B
Disassembly and Assembly Disassembly 117
11. Lift the right side of the Printer mechanism carefully while releasing one hook for
securing the Printer mechanism to the Lower housing from the backside of the
Printer by using the tweezers.
Figure 4-52. Printer mechanism removal (2)
12. Remove the Printer mechanism by lifting it at the points shown below (In this
time, the Paper eject roller is also removed with the Printer mechanism).
Figure 4-53. Printer mechanism removal
CAUTION
When lifting the Printer mechanism from the Lower housing, be
careful not to drip off the ink from the end (Waste drain ink pad
side) of the ink tube.
Do not remove the Printer mechanism upward by lifting it at the
unspecified position to avoid the deformation of the Main frame.
Step2)
Lift up
Hooks
Step1)
Push
Backside
This figure is the Stylus C60. Unlike the Stylus
C50/C60/C61/C62, the Stylus Photo 810/820/830
has porous pad in the lower housing.
When assembling the Printer mechanism to the Lower housing,
Make sure to set the Main frame reinforcing plate correctly
at the rightmost screw.
Figure 4-54. Reinforcing plate setting position
Avoid to damage the coated surface of the PF roller by using
the OHP sheet as shown figure below.
Figure 4-55. Printer mechanism assembling(1)
Reinforcing plate
OHP sheet
This figure is the Stylus C60. Unlike the Stylus
C50/C60/C61/C62, the Stylus Photo 810/820/830
has porous pad in the lower housing.