Filter
Top Products
Problems when projection starts
No power supplied
Check Remedy
Did you press the [t] button? Press the [t] button to turn the power on.
Are the indicators switched off? The power cable is not connected correctly or power is not being supplied normally.
Disconnect and then reconnect the power cable. s Quick Start Guide
Check that your electrical outlet or power source is functioning correctly.
Do the indicators turn on and off when the power cable is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If
this does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and
contact your local dealer or the nearest address provided in the Support and Service Guide. s Epson Projector
Contact List
Is the Control Panel Lock set to Full Lock?
Press the [t] button on the Remote Control. If you do not want to use Control Panel Lock, change the setting to
Off. s Settings Menu - Control Panel Lock p.31
Is the correct setting for the remote receiver selected?
Check the Remote Receiver from the Configuration Menu. s Settings Menu - Remote Receiver p.37
Other problems
No sound can be heard or the sound is faint
Check Remedy
Is the audio source connected correctly? Disconnect the cable from the Audio-L/R input port, and then reconnect the cable.
Is the volume adjusted to the minimum setting?
Adjust the volume so that sound can be heard. s p.37 s Quick Start Guide
Is A/V Mute active?
Press the [A/V Mute] button on the Remote Control to cancel A/V Mute. s p.19
Is the audio cable's specification "No resistance"? When using a commercially available audio cable, make sure it is labeled "No resistance".
No sound can be heard from the microphone
Check Remedy
Is the microphone connected correctly? Disconnect the cable from the Mic Input Port, and then reconnect the cable.
Problem Solving
63