Filter
Top Products
FCC
COMPLIANCE STATEMENT
FOR
AMERICAN
USERS
This equipment has been tested and found to comply with the limits for a Class
B
digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in
a
residential installation. This
equipment generates, uses, and can radiate radio frequency energy and,
if
not installed
and used
in
accordance with the instructions, may cause harmful interference to radio
communications However. there
is
no guarantee that interference will not occur in a
particular installation.
If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user
is
encouraged to try to correct the interference by one or more of the following
measures:
—
Reorient or relocate the receiving antenna
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the
receiver
is
connected.
—
Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received,
including interference that may cause undesired operation.
FOR
CANADIAN
USERS
This digital apparatus does not exceed the Class
B
limits for radio noise emissions from
digital
apparatus as set out in the radio interference regulations of the Canadian
Department of Communications
Le présent appareil numérique n´émet
pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques
de Class
B
prescrites dans le règlement sur le
brouillage radioélectrique édicté
par le Ministére des Communications du Canada.
WARNING
The connection of a non-shielded printer interface cable to this printer will invalidate
the FCC Certification of this device and may cause interference levels which exceed the
limits established by the FCC for this equipment
If
this equipment has more than one
interface
connector. do not leave cables connected to unused interfaces.
Seiko Epson Corporation shall not be liable against any damages or problems arising
from the use of any options or any consumable products other than those designated
as Original Epson Products or Epson Approved Products by Seiko Epson Corporation
NOTICE
All rights reserved. Reproduction of any part of this manual in any form whatsoever
without Seiko Epson’s express written permission
is
forbidden.
The contents of this manual are subject to change without notice.
All efforts have been made to ensure the accuracy of this manual. However, should any
errors be detected, Seiko Epson would greatly appreciate being informed of them.
The above notwithstanding, Seiko Epson can assume no responsibility for any errors
in
this manual or their consequences
Copyright © 1990
by Seiko Epson Corporation, Nagano. Japan