Filter
Top Products
DIP
switch
and
jumper
settings
Before you install the C82307* /C82308* interface, you
may need to adjust the DIP-switch 2, DIP-switch 3, and
jumper settings. You can change the DIP-switch 1
settings
after
you install the interface. When making
DIP-switch setting changes, it
is
best to use a pointed
device, such as a ball-point pen or small screwdriver.
Caution
All changes of DIP-switch and jumper settings should be
made with the
printer
power turned off. New settings
become valid only when the printer
is
turned on.
DIP
switches
The settings on DIP switches allow you to change
interface functions. The three sets of DIP switches on
the C82307* /C82308* are labelled SWl, SW2, and
SW3.
Each set contains a number
of
individual toggle-
type switches
that
can be set either on or off. The
individual switches are referred to by set (SW1, SW2, or
SW3)
and number. Therefore, the switch in set SW1
marked by the small number 3 is called DIP switchl-3.
5