Filter
Top Products
You can switch between the front and rear tractors at any time
when you are using the pull tractor. Just press the
FRONT/REAR
button and then use the
LF/FF
button to feed the
paper the additional distance to the pull tractor. (Labels require
special handling. See the section on using labels in Chapter 2.)
The tear-off feature does not work when the pull tractor is
installed. To tear off documents, press the
LF/FF
button to
advance the paper to a point where it can be tom off.
The following steps show you how to load paper using the
optional pull tractor (already installed) with the printer’s
built-in rear tractor. If you have not yet installed the pull
tractor, load paper onto the rear tractor and then install the pull
tractor as described earlier in this chapter.
1.
Open the top cover.
Note:
If paper is on the rear tractor, in either the fop-of-form or standby
position, skip to Step 6.
2.
Pull the levers on the pull tractor toward you to release the
pull tractor.
4-10
Using the Printer Options