Filter
Top Products
Once the Configuration menu content has been set for one projector, you
can use it to perform batch setup for multiple projectors (batch setup
function). The batch setup function is only for projectors with the same
model number.
Use one of the following methods.
• Setup using a USB memory.
• Setup by connecting the computer and projector with a USB cable.
This manual explains the USB storage device and the USB cable methods.
a
• The following content is not reflected by the batch setup function.
- Settings in the Network menu (except for the Mail menu and the
Others menu)
- Lamp Hours and Status from the Info menu
• Perform batch setup before adjusting the projected image.
Adjustment values for the projected image, such as H/V-Keystone
correction, are reflected by the batch setup function. If batch setup is
performed after adjusting the projected image, the adjustments you
made may change.
• By using the batch setup function, the registered User's Logo is set
for the other projectors. Do not register confidential information and
so on as the User's Logo.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due
to a power failure, communication error, and so on, the customer is responsible
for any repair costs incurred.
Setting Up Using a USB Storage Device
This section explains how to perform batch setup using a USB storage
device.
a
• Use a FAT format USB storage device.
• The batch setup function cannot be used by USB storage devices that
incorporate security functions. Use a USB storage device that does
not incorporate security functions.
• The batch setup function cannot be used by USB card readers or
USB hard disks.
Saving settings to the USB storage device
a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the USB storage device to the projector's USB-A port.
Performing Batch Setup for Multiple Projectors
120