Filter
Top Products
d
Copy the batch setup file (PJCONFDATA.bin) that you saved to
your computer to the top level folder of the removable disk.
a
Do not copy any files or folders other than the batch setup file
to the removable disk.
e
Perform Remove USB device on your computer, and then
disconnect the USB cable.
a
When using OS X, perform Remove EPSON_PJ.
When all of the indicators start flashing, the settings are being
written.
Caution
Do not disconnect the power cord from the projector while the settings
are being written. If the power cord is disconnected, the projector may
not start correctly.
When writing completes normally, the projector enters standby
status.
When Setup Fails
The indicators notify you if an error occurs. Check the status of the
indicators.
Status of the Indicators Remedy
Lamp: Orange - flashing fast
Temp: Orange - flashing fast
The batch setup file may be corrupt, or the USB
storage device or USB cable may not be connected
correctly. Disconnect the USB storage device or the
USB cable, unplug and then plug in the projector's
power cord, and then try again.
Power: Blue - flashing fast
Status: Blue - flashing fast
Lamp: Orange - flashing fast
Temp: Orange - flashing fast
Writing the settings may have failed and an error
may have occurred in the projector's firmware.
Stop using the projector, remove the power plug
from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson
Projector Contact List.
Performing Batch Setup for Multiple Projectors
126