Filter
Top Products
Sub Menu Function
Wired LAN
You can make network settings.
DHCP: You can set whether or not (On/Off) to use DHCP.
If this is set to On you cannot set any more addresses.
IP Address: You can input the IP address assigned to the projector.
*
You can enter a number from 0 to 255 in each field of the address. However, the following IP Addresses cannot be used.
0.0.0.0, 0.x.x.x, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask: You can input the subnet mask for the projector.
*
You can enter a number from 0 to 255 in each field of the address. However, the following Subnet Masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can input the IP address for the gateway for the projector.
*
You can enter a number from 0 to 255 in each field of the address. However, the following Gateway Addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
MAC Address: You can display the MAC address for the projector.
PJLink Password
Set a Password to use when you access the projector using compatible PJLink software.
*
s p.113
You can enter up to 32 single-byte alphanumeric characters.
Web Control Password
Set a password to use when making settings and controlling the projector using Web Control.
*
You can enter up to 8 single-byte
alphanumeric characters.
Web control is a computer function that allows you to set up and control the projector by using a web browser on the computer
running EasyMP Monitor. s EasyMP Monitor Operation Guide
SNMP
You can make
SNMP
g
settings.
Trap IP Address 1/Trap IP Address 2: You can register up to two addresses as the SNMP trap notification destination.
*
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be
managed by a network expert.
List of Functions
52