Filter
Top Products
List of Functions
35
Extended Menu
Sub Menu Function
Display You can make settings related to the projector's display.
Messages: You can set whether to display (On) or not display (Off) the source name when you change the input source, the color mode name when
you change the color mode, a message when no image signal is input, and so on.
Display Background
*1
: You can set the screen status for when no image signal is available to "Black", "Blue", or "Logo".
Startup Screen
*1
: You can set if the startup screen (the image projected when starting the projector) is displayed or not.
A/V Mute
*1
: You can set the screen displayed during A/V Mute as "Black", "Blue", or "Logo".
User's Logo
*1
You can change the user's logo that is displayed as a background and displayed during A/V Mute. s p.68
Projection You can set from the following according to the way the projector is setup. s p.57
"Front" "Front/Ceiling" "Rear" "Rear/Ceiling"
You can change the setting as follows by pressing down the [A/V Mute] button on the remote control for about five seconds.
"Front" W "Front/Ceiling"
"Rear" W "Rear/Ceiling"
Operation Direct Power On: You can set whether Direct Power On is enabled (On) or disabled (Off).
When it is set to "On" and the projector power cable is connected to an electrical outlet, be aware that sudden surges of electricity when power
comes back on after a power outage may cause the projector to turn on automatically.
Sleep Mode: You can set whether projection stops automatically (On) or not (Off) when no operations are carried out for a preset time while no
image signals are being input.
Sleep Mode Timer: The time that must elapse until the projector enters sleep mode can be set to between 1 and 30 minutes.
High Altitude Mode: Set to "On" when using the projector above an altitude of 1500 m.
*1 When "User's Logo Protect" is set to "On" in "Password Protect", settings relating to user's logo cannot be changed. You can make changes after setting "User's
Logo Protect" to "Off". s p.25