Filter
Top Products
76
List of ESC/VP21 Commands
Command List
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message
is output and a ":" is returned.
* Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
Cable Layouts
f Serial connection
• Connector shape : D-Sub 9-pin (male)
• Projector input connector : RS-232C
Item Command
Power ON/OFF ON PWR ON
OFF PWR OFF
Signal selection Video SOURCE 41
S-Video SOURCE 42
A/V Mute ON/OFF ON MUTE ON
OFF MUTE OFF
A/V Mute selection Black MSEL 00
Blue MSEL 01
Logo MSEL 02
Item
Command
Computer1
Port
Computer2
Port
Signal selection Computer (Auto) SOURCE 1F SOURCE 2F
Computer SOURCE 11 SOURCE 21
Component Video SOURCE 14 SOURCE 24
<At the projector> (PC serial cable) <At the computer>
Signal Function
GND 5 5 GND
GND Signal wire ground
RD 2 3 TD
TD Transmit data
TD 3 2 RD
RD Receive data
DTR 4 6 DSR
DSR Data set ready
DSR 6 4 DTR
DTR Data terminal ready
<At the projector> <At the computer>