Filter
Top Products
■ ■ ■ ■
64
Problems with the Image or Sound
❑ An image does not appear on the screen.
Check that the power light is on and the lens cover is off.
Also make sure the cables are installed correctly, as
described in Chapter 1.
The correct image source may not be selected. Press the
Source button on the remote control or the Source button
on the appropriate input operation panel to choose another
image source.
❑ Only part of the computer image is displayed.
If the computer’s output resolution setting is higher than
1024 × 768 (EMP-710/700) or 800 x 600 (EMP-500),
the projector resizes the image. If the computer output is
not compatible with this resizing, choose a different display
setting on the computer. For supported display settings, see
“Supported Monitor Displays” on page 69, 70.
You also may need to modify existing presentation files if
you created them for a different resolution. See your
software manual for specific information.
❑ The message NO SIGNAL is displayed.
An image source not connected to the projector is selected,
the signal is not being output from the computer, or the
signal is not reaching the projector. Make sure the
connectors are securely attached to both the projector and
the image source. Then check that the image source is
selected correctly. When NO SIGNAL is displayed, you
cannot access the Video (computer/video) menu.