Filter
Top Products
Page length does not match the length of the paper.
Change the page-length setting with DIP switches 2-1 and 2-2.
See page 3-10.
Check the page length set by your software and adjust it if
necessary.
Regular gaps occur in the printout.
One-inch skip-over-perforation may be set. Set DIP switch
1-8
off.
Skip-over-perforation is set, but the perforation does not fall in
the center of the skip.
Make sure the page-length DIP-switch setting matches the
page length of your paper. See page 3-10.
If your software controls the top and bottom margins, set DIP
switch 1-8 off.
Vertical printed lines do not align.
Turn DIP switch 1-5 on for unidirectional printing.
Printing starts too low on the page, or the bottom part of one page
is printed at the top of the next page.
Be sure to choose the correct printer when you choose a printer
from your software’s setup menu. See page
1-15.
Use your software to specify the type of paper you are using
(single-sheet or continuous).
6-6 Troubleshooting