Filter
Top Products
Adjusting the tear-off position
If the perforation is not aligned with the tear-off edge, adjust
the tear-off position by following the steps below:
1. Make sure the paper is in the tear-off position and the TEAR
OFF
light is on.
2. While holding down the ALT button, press the LOAD/EJECT
button to adjust the
tear-off position to a lower position on
the page or press the LF/FF button to adjust the tear-off
position to a higher position on the page. The printer
remembers the new tear-off position.
3. Tear off any printed pages.
4.
When you begin printing, the printer automatically feeds the
paper back to the loading position and begins printing.
(You can also manually feed the paper back to the loading
position by pressing the
LOAD/EJECT
or
TEAR OFF
button.)
Note:
The printer has a minimum and maximum tear-off position. If
you try to advance the loading position beyond these limits, the
printer beeps and the paper stops moving.
When the paper
reaches the factory-set tear-off position, the
printer beeps and paper feeding pauses briefly.
Use the factory
setting as a reference point when adjusting the tear-off position.
Using the Printer
3-19