Filter
Top Products
Plugging in the Printer
1.
Make sure that the power switch is turned off. It is off when
the 0 side of the switch is pressed down.
2.
Check the label on the back of the printer to make sure the
voltage required by the printer matches that of your
electrical outlet. Also, make sure that you have the correct
power cable for your power source.
Caution:
It
is not possible to adjust the
printerfor
use at another
voltage.
lf
the rated voltage and your outlet voltage do not
match, contact your dealer for assistance. Do not plug in the
power cord.
3.
If the power cord is not attached to the printer, connect it to
the AC inlet on the back of the printer.
4.
Plug the power cord into a properly grounded electrical
outlet.
Setting Up Your Printer
1-7