Filter
Top Products
ECO-FLO CONTINUOUS INK SYSTEM
Perma
Jet
Assembly Instructions for
:
2100 Ink System
1
Epson 2100 Eco-Flo Shown
IMPORTANT
If your printer is new, set it up according to
the enclosed manufacturers instructions.
This is a check to ensure your new printer
and drivers are working correctly before the
Eco-Flo System is installed.
EPSON PRINTER
Epson 2100
Part No. A26421
.
It is very important you read these instructions carefully before you begin!
We will take you through the following steps:
1 Preparing your Injector
2 Setting up of the Inks in the bottle tray
3 Installation of the modified injector to your printer
4 Fitting of the Tube Supports System
5 Producing your first print.
Only start work on the installation once you have read the
instructions fully!
What you will need to Install the Eco-Flo 2100
• Complete Eco-Flo 2100 Kit
• Sharp Blade (Stanley Knife type) & Scissors
• Measuring Tape or Ruler
• Marking Pen or Pencil
• Paper Towels
Please read carefully before you continue and
refer to the components diagram over the
page.
What is included in your Eco-Flo 2100 Kit
• Injector Set with tubes attached
• Set of 7 Inks & empty 100ml bottles
• Black Tube Support Bracket with Hook &
Loop Fastener fitted
• Bottle Holder Tray
• Special Chip Block
• 1 Grey/White Tube Clip with adhesive pad
• Installation Instructions and Profiles CD
• 10ml Syringe & wing adaptor
• Pair of latex gloves
• Special Foam Block
• 7 Tube Clamps
• 7 Bottle Caps & Clear Piping Tubes
Check List for components
Black Tube
Su
pp
ort Bracket
Set of 7
125ml Inks
Wing Adaptor