Epson 2100 Printer User Manual


 
ECO-FLO CONTINUOUS INK SYSTEM
Perma
Jet
Assembly Instructions for
:
2100 Ink System
1
Epson 2100 Eco-Flo Shown
IMPORTANT
If your printer is new, set it up according to
the enclosed manufacturers instructions.
This is a check to ensure your new printer
and drivers are working correctly before the
Eco-Flo System is installed.
EPSON PRINTER
Epson 2100
Part No. A26421
.
It is very important you read these instructions carefully before you begin!
We will take you through the following steps:
1 Preparing your Injector
2 Setting up of the Inks in the bottle tray
3 Installation of the modified injector to your printer
4 Fitting of the Tube Supports System
5 Producing your first print.
Only start work on the installation once you have read the
instructions fully!
What you will need to Install the Eco-Flo 2100
Complete Eco-Flo 2100 Kit
Sharp Blade (Stanley Knife type) & Scissors
Measuring Tape or Ruler
Marking Pen or Pencil
Paper Towels
Please read carefully before you continue and
refer to the components diagram over the
page.
What is included in your Eco-Flo 2100 Kit
Injector Set with tubes attached
Set of 7 Inks & empty 100ml bottles
Black Tube Support Bracket with Hook &
Loop Fastener fitted
Bottle Holder Tray
Special Chip Block
1 Grey/White Tube Clip with adhesive pad
Installation Instructions and Profiles CD
10ml Syringe & wing adaptor
Pair of latex gloves
Special Foam Block
7 Tube Clamps
7 Bottle Caps & Clear Piping Tubes
Check List for components
Black Tube
Su
pp
ort Bracket
Set of 7
125ml Inks
Wing Adaptor