Filter
Top Products
Press
Y
and
Enter
to start the test. Press
N
and
Enter
to stop
the operation.
Hard Disk Error Messages
DIAG displays two types of error messages
while testing the
hard disk: messages DIAG generates and those the controller
generates.
DIAG displays the following message if you attempt to run the
Performance Test with less than 128KB of memory:
INSUFFICIENT MEMORY FOR DATA TRANSFER
Minimum memory required is - 128KB
The controller displays one of the following messages when an
error occurs during a diagnostics procedure:
Address mark not found
Attachment failed to respond
Bad ECC on disk read
Bad sector flag detected
Controller has failed
Drive activity failed
ECC corrected data error
Requested sector not found
Reset failed
Seek operation failed
Write fault on selected drive
When you see one of these error messages, check the drive,
controller, cables, and power connectors. Remove and re-install
the hard disk cartridge. If you still get an error, contact your
dealer.
30 System Diagnostics