4 • Using the ELP Link II Software
62
Installing the Software from Windows 95
Perform the following steps to set up the software:
1.Insert the Link II for Windows installation diskette into a diskette
drive (A: or B: as appropriate).
2.Click Start.
3.Click the Run menu option. The Run dialog box appears:
4.Type A:\SETUP (or B:\SETUP as appropriate), then press Enter
or click OK. The ELP Link II introduction appears. Press C to
continue.
5.To accept the default location for where the software should be
installed, press C to continue. Otherwise, enter a new directory
name and then press C.
6.The Link II software communicates with the projector using the
computer’s serial communication (COM) port. Specify which
COM port to use, then press C to continue. (Most likely, your
computer is using COM 1.)
pro-ch4.fm Page 62 Monday, November 10, 1997 1:37 PM