Filter
Top Products
19
Setting Up the SpectroProofer | 19
Initializing the SpectroProofer
The SpectroProofer must be aligned before you use it for the first time. You
only need to perform this procedure once. You don’t need to repeat the
alignment if you remove and re-install the SpectroProofer.
1. Confirm that the SpectroProofer is powered on by checking its green
status light. The SpectroProofer must be powered on before you turn on
the printer, or it won’t be recognized.
2. Turn on the printer.
3. Load 24-inch or 44-inch roll paper in your printer, depending your
model. Follow the paper loading instructions in your Printer Guide.
4. Select
OPTIONS SETUP, SpectroProofer, DEVICE ALIGNMENT
and
EXECUTE, and then press the OK button on the printer’s control
panel.
The printer automatically prints out and measures an adjustment
pattern. This process takes about one minute to complete.
5. When the alignment is complete,
READY is displayed on the printer’s
control panel.
Your SpectroProofer is now properly installed. See the manual that came
with your RIP or color measuring software for instructions on using the
SpectroProofer.
Note:
The SpectroProofer does
not have a power switch. It
is on when it is plugged in
and receiving power.