Filter
Top Products
2-2
Connecting the Host Computer to the Printer
n
Connecting the interface cable
Connect the printer with the host ECR (host computer) through an interface cable
matching the specifications of the printer and the host ECR (host computer).
Be sure to use a drawer that matches the printer’s specifications.
<TM-U300A/U300B>
Connect the interface cable according to the following procedure.
➀
Turn off the printer and the ECR (host computer).
➁
Plug the interface cable connector into the interface connector on the printer;
then fasten the screw on both sides of the connector.
➂
Plug the drawer kick-out cable connector into the drawer kick-out connector on
the printer. (When removing the drawer kick-out cable, press in on the
connector’s clip and pulling out.)
Drawer Kick-out Connector
,
Drawer Kick-out Cable
Serial Interface Cable Connector
r
I
NOTE:
l
Your printer
plan to use
comes with inch-type hexagonal lock screws installed. If you
an interface cable that requires millimeter-type lock screws,
replace the inch-type screws with the enclosed millimeter-type screws using
a hex screwdriver (5 mm). To distinguish the two types of screws, see the
figure below.
Notch (one or more line)
Inch-type
Millimeter-type
-
6