Filter
Top Products
2.
If you have just made a change in your system configuration,
your computer may take a few minutes to complete its
power-on diagnostics. The first time you turn on your
computer after making such a change, it can take several
minutes to finish its self test, depending on what you
changed. If the computer does not display the operating
system prompt after five minutes, press the RESET button
and try again. If that doesn’t work, insert your main
operating system diskette in drive A and press the
RESET
button. If the computer still does not boot, contact your
Epson dealer.
3.
Did you enter the correct password? See “Password
Problems,” below.
4. Could your software be causing the problem? If you are
running an application program, see “Software Problems,”
later in this chapter.
5.
The problem could be caused by your keyboard. See
“Keyboard Problems,” later in this chapter.
6.
If you want to stop whatever the computer is doing and
return to the MS-DOS command prom
t, hold down the
[cbl
key and press
[8nak)
(or press
c!i
c
. See Chapter 1 for
more information on stopping a command or program.
7.
If your computer still does not respond, you can reset it
using the
t5
cm
[rJI)
I=]
command or the
RESET
button. See “Resetting Your Computer” in Chapter 1 for
more information.
8.
If resetting the computer does not work, turn off the
computer and wait at least 10 seconds. If you do not have a
hard disk drive, insert your main operating system diskette
in drive A; then turn on the computer. It should load the
operating system.
Troubleshooting 7-7