Filter
Top Products
5. Secure the end of the card to the back of the computer with
the retaining screw.
6.
After you replace the computer’s cover, check the
documentation that came with your card to see if there are
any post-installation procedures you need to perform
before you start using the option. If you installed a card
with an additional interface, you may need to run SETUP to
change one of the computer’s built-in interface settings. See
Chapter 2 of the
Setup Guide
for instructions.
Removing an Option Card
If you need to remove an option card, follow these steps:
1.
Remove the screw securing the card to the back of the
computer and pull it straight up and out of the slot.
i
3-10
Installing and Removing Options