Filter
Top Products
List of Functions
77
Web Control Password Set a password to use when making settings and controlling the projector using Web Control.
*
You can enter up to 8 single-byte
alphanumeric characters.
Web control is a function that allows you to set up and control the projector using your computer’s web browser. For more
information, see the EasyMP Monitor Operation Guide.
SNMP You can make SNMP settings.
Trap IP Address 1/Trap IP Address 2: You can register up to two addresses as the SNMP trap notification destination.
*
To use SNMP to monitor the projector, you need to install an SNMP manager program on your computer. SNMP should be
managed by a network expert.
Mail When this is set, you receive an e-mail notification if a problem or warning occurs in the projector. For information on the contents
of the sent email.
Mail Notification: You can set whether or not (On/Off) to be notified by e-mail. If this is set to Off you cannot set any more
addresses.
SMTP Server: You can input the IP address for the SMTP server for the projector.
*
You can enter a number from 0 to 255 in each field of the address. However, the following IP Addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Port Number: You can display the SMTP server's port number.
The default value is 25. When editing settings from Web Control, you can change Port Number by entering a valid number from 1
to 65535.
Address 1 Setting/Address 2 Setting/Address 3 Setting: You can enter the e-mail address
*
and the contents of the message to
receive notification when a problem or warning occurs. You can register up to three destinations. You can enter up to 64
single-byte alphanumeric characters for the e-mail addresses.
AMX Device Discovery When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery. Set
this to Off if the projector is not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
Projector Name Displays the projector name used to identify the projector when connected to a network.
Reset You can reset all adjustment values for the Network menu to their default settings.
To return all menu items to their default settings, see s p.95
Sub Menu Function