Filter
Top Products
Installation Procedure
EN/LZT 108 6429 R1 15 (47)
May 2003
2.3 Connect the Modem
Connect the modem according to the following instructions:
1 Connect one end of the provided ADSL Line cable to the modem's LINE port.
Connect the other end to the ADSL service port (splitter/filter or phone outlet).
2 Connect the square plug of the provided USB cable to the USB port on the back
of the modem. Connect the flat plug to the USB port on your PC. This port is
most likely marked with the standard USB symbol.
Important Notes on attaching other USB Devices:
If you are going to attach other USB devices, such as USB mouse, keyboard or
hub, please plug them to your PC before connecting the modem. Otherwise, the
pre-attached USB modem will consume a fixed bandwidth and the remaining
bandwidth will not be enough for other USB devices.
If this is the case, you will se an error message warning you that the USB
controller bandwidth is exceeded. The additional USB device may not function
properly.
For example, your modem is attached already and you need to add an USB mouse
to your PC. In this case:
• Unplug the modem to release the bandwidth.
• Plug the USB mouse to your PC and then re-plug the modem. The modem
will now adjust to use the remaining bandwidth.
3 As soon as the USB cable is connected to the PC, the "Found New Hardware"
dialog is shown and the installation of the drivers proceeds.