Filter
Top Products
Installation Procedure
EN/LZT 108 6429 R1 9 (47)
May 2003
2 Installation Procedure
The step-by-step instructions in this chapter guides you through the complete
installation procedure for all supported operating systems. Notes will indicate when
operating system specific differences occur.
The installation procedure is divided into two steps:
• Driver installation;
Installation of driver and, if required, user parameter input.
• Connect the modem;
The physical cable connections.
2.1 Before You Start
Prior to installing the driver, consult with your ISP or system administrator about the
connection type and collect related information. You will be prompted for these
information during installation.
Connection Type Encapsulation and Multiplexing method Network Information
LAN RFC 1577 Classical IPoATM
RFC 1483 IPoATM Bridged LLC Encapsulation
RFC 1483 IPoATM Bridged VC Encapsulation
RFC 1483 IPoATM Routed LLC Encapsulation
RFC 1483 IPoATM Routed VC Encapsulation
TCP/IP information:
- IP address
- Subnet mask
- DNS
- Gateway
WAN RFC 2364 PPPoATM LLC Encapsulation
RFC 2364 PPPoATM NULL Encapsulation
RFC 2516 PPPoE Encapsulation
Internet Account information:
- User name
- Password
In addition you need the following information:
• Modulation (Transmission Standards): T1.413, Multimode, G.Lite or G.DMT
• The values of VPI and VCI
2.2 Driver Installation
Note:
DO NOT connect any cables yet. You will be notified
when to connect the modem during the installation
process.
1 Close ALL Windows applications and insert the Installatioin CD into your
CD-ROM drive.