Filter
Top Products
CrossPoint / MAV Matrix Switchers • Remote Control
Remote Control, cont’d
4-8
CrossPoint / MAV Matrix Switchers • Remote Control
4-9
Refer also to the CrossPoint 450 Plus / MAV Plus User’s Manual at www.extron.com. Refer also to the CrossPoint 450 Plus / MAV Plus User’s Manual at www.extron.com.
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
Information requests
Information request I
V
X*XX(•AX*XX(TX1@UX1#]
VX*XX( = video size, AX*XX( = audio size,
T
X1@ = BME type, UX1# = # of BMEs in system.
Example:
MAV 450 Plus 6448 with a
connected audio BME
I
V64X48•A64X48•T2•U2
]
This low resolution matrix switcher (T2) has 64 video
and 64 audio inputs by 48 video and 48 audio inputs.
This is a two BME system (a video and audio BME).
Request part number N
X1)]
Query controller firmware version Q
X1!]
Example:
Q
1.23
]
The factory-installed controller firmware version is
1.23 (sample value only).
N
X1$ = Name (Up to 240 alphanumeric characters)
X1% = IP address ###.###.###.###
X1^ = DHCP 0 = off 1 = on
X1& = Verbose mode 0 = clear/none (default for Telnet connection) 2 = tagged responses for queries
1 = verbose mode (RS-232/RS-422 default) 3 = verbose mode and tagged for queries
X1* = Port timeout 1 (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes)
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
IP setup
Set matrix name
EX1$CN} Ipn•X1$]
Read matrix name
ECN} X1$]
Reset matrix name to factory default
E•CN} Ipn•X1$]
Model name plus the last 3 pairs of the MAC address.
Set IP address
EX1%CI} IpiX1%]
Read IP address
ECI} X1%]
Set subnet mask
EX1%CS} IpsX1%]
Read subnet mask
ECS} X1%]
Set gateway IP address
EX1%CG} IpgX1%]
Read gateway IP address
ECG} X1%]
Set DHCP on or off
EX1^DH} IdhX1^]
Read DHCP on/off status
EDH} X1^]
Set verbose mode
EX1&CV} VrbX1&]
Read verbose mode
ECV} X1&]
Configure current port timeout
E0*X1*TC} Pti0*X1*]
Read current port timeout
E0TC} X1*]
Configure global IP port timeout
E1*X1*TC} Pti1*X1*]
Read global IP port timeout
E1TC} X1*]
N
X* = Inputs Total number of inputs for this switcher
X( = Outputs Total number of outputs for this switcher
X1) = Part number See the CrossPoint 450 Plus / MAV Plus User’s Manual, for a complete list of part numbers.
X1! = Firmware version number to second decimal place (x.xx)
X1@ = BME type 1 = wideband video 3 = sync 5 = mono audio
2 = low resolution video 4 = stereo audio
X1# = # of connected BMEs 1 through 6