Extron electronic 8 PLUS Switch User Manual


 
Extron • Model 8 PLUS & Model 10 PLUS Switchers • User’s Manual
Model 8/10 PLUS Switcher Installation Guide
The recommended installation procedure for the Model 8
PLUS and Model 10 PLUS Switchers is:
1. Prior to installing the switcher (because it requires opening the
case) do the procedure "Changing the Baud Rate" on page 2-7
if necessary.
2. If the switcher is to be rack mounted, install it in the rack using
the procedure "Rack Mounting the Switcher" on page A-4.
3. Connect switcher input and output cables using the diagram on
the facing page as a general guide (also see "Connecting the
Inputs" below).
4. Set the Output Select DIP Switches using the procedure
"Output Select DIP Switch Setting" on page 2-5.
5. If the switcher RS-232 connector is to be used, connect it to
the computer using the procedure "Model 8/10 Switcher
Connection to Computer" on page 2-8.
6. If the Extron KP-10 Remote Control is to be used, connect it to
the switcher using the procedure on page A-2.
7. If the Extron IR-10 Remote control is to be used, connect it to
the switcher using the procedure on page A-3.
8. If a third party remote control device is to be used, connect it to
the switcher using the information on page A-1 as a guide.
9. Upon completion of switcher installation, use "Model 8/10
Switcher Operation" on page 2-1 as a guide to operate the
switcher .
10. If RS-232 control of the switcher is to be used, use Chapter 3,
"Model 8/10 PLUS RS-232 Control" as a guide.
_ If a projector is connected to the RGB output and picture
sizing, rolling, or other forms of distortion occur for an instant
after the input is switched, the Triple Action Switching
TM
adjustment on page 2-8 may be required.
Connecting the Inputs
Use the chart below as a guide to connecting inputs to the
four BNC input connectors shown to the right. Use the inputs
listed under the appropriate video format at the top of the
table.
RGBS RGsB S-Video/SVHS NTSC/PAL
R = RED R = RED R (Right) Audio R (Right) Audio
G = Green G = Green Y Video Video
B = Blue B = Blue L (Left) Audio L (Left) Audio
Sync Unused C Video Unused
Page 2-3
Model 8/10 PLUS Operation and Configuration