Filter
Top Products
DAV101CM, DAS101CM • Installation and Operation
Installation and Operation, cont’d
2-6
C
The pin assignments of the DAS’s power input and
power loop-through ports are different from those of
the DAV modules’ power input. Double-check your
work against the wiring diagram. Power wires must
be attached to the correct terminals on each connector
or these products can be damaged.
+
TECHNICAL SUPPORT:
800.633.9876
714.491.1500
www.extron.com
MADE IN USA
POWER IN
12V @0.3A
DAV101CM
(back view)
12 VDC, 1 A
DC Power
Adapter
OUTIN
DAS101CM
(back view)
Power In
Loop Out to DAV101CM or CIA Interface
DAV-DAS power interconnection
c
Audio output — Wire this 5-pole, 3.5 mm, direct insertion
captive screw connector as shown below for either balanced or
unbalanced stereo audio output.
DAS101CM-1/-2/-5
Bottom View
DAS101CM-3/-4/-6
Balanced
Stereo Output Wiring
Unbalanced
Stereo Output Wiring
12
VDC
0.1 A
12
VDC
0.1 A
Right, tip, +
Left, tip, +
Ground, sleeve(s),
Gnd, sleeve(s),
Left, ring, –
See caution.
Left, tip, +
See caution.
Right, ring, –
Right, tip, +
N
The left and right channels of the DAS101CM-3/-4/-6 are
reversed (R-L instead of L-R) relative to the
DAS101CM-1/-2/-5, as shown above.
C
For unbalanced output, connect the sleeve to ground
(Gnd,
_
). Connecting the sleeve to a negative (-)
terminal will damage the audio output circuits.