Filter
Top Products
Symbols Used in this Guide
When programming in the eld, certain characters are most conveniently represented by their
hexadecimal rather than their ASCII values. The table below shows the hexadecimal equivalent
of each ASCII character:
ASCII to HEX Conversion Table
Space
.
Table 2. ASCII to HEX Conversion Table
] — carriage return with line feed
} — carriage return (no line feed)
• — space character
E — Escape key
The
X/ values defined in this section are the variables used in the fields of the Command
Response Table.
X! — Output (1 or 2)
X@ — Status
0 = disabled, off, or undetected
1 = enabled, on, or detected
X# — Video color bit depth
0 = auto (based on EDID of sink)
1 = force 8-bit
2 = pass-through
X$ — EDID memory location (see “HDMI DA2 Memory Locations" Table on page 12)
X% — EDID data as 256 bytes of Hex data (text representation)
X^ — Native resolution and refresh rate (translated from Hex)
for example: 1600x1200 @60Hz
X& — Controller software version to the second decimal place
Error Messages
E01 — Invalid input channel number (too large)
E10 — Invalid command
E13 — Invalid value (too large)
HDMI DA2 • SIS Commands 18