Filter
Top Products
Installation
This section of the guide describes the following topics concerned with the installation and
setup of the HDMI DA2 distribution amplier.
z Installation Overview
z Rear Panel Features
z Connecting the Power Supply
z Connecting the Input Source
z Connecting Output Displays
z Wiring for RS-232 Control
z Connecting to the USB Port
Installation Overview
To install and set up the HDMI DA2, follow these instructions:
1. Mount the HDMI DA2 in a suitable location (see page 27).
2. Connect the provided 12 VDC power supply to the power connector. Be sure to read
all attention points, notes, and warnings in this section before powering up the HDMI DA2
(see page 4).
3. Connect the display devices to the HDMI DA2 and power them on (see page 5).
The distribution amplier automatically reads and stores EDID from the display connected
to output 1.
4. If necessary, connect a control PC to the rear panel captive screw connector (see
page 6) or the front panel USB port (see page 7).
5. Congure the HDMI DA2, using SIS commands (see page 17).
6. Connect and power on the input device (see page 5).
Rear Panel Features
POWER
12V
0.4A MAX
RS-232
TxRx G
12
INPUT
REMOTE
OUTPUTS
ab dc
Figure 2. HDMI DA2 Rear Panel
a
Power supply connector
b
HDMI input connector
c
HDMI output connectors
d
RS-232 connectors
HDMI DA2 • Installation 3