Filter
Top Products
VersaTools
®
MTP 15HD A Series • InstallationVersaTools
®
MTP 15HD A Series • Installation
VersaTools
®
MTP 15HD A Series, cont’d
VersaTools
®
MTP 15HD A Series • Installation
VersaTools
®
MTP 15HD A Series • Installation
MTP T VGA RS
MTP T VGA RS
MTP T VGA RS
Figure 2 — Mounting the MTP on a standard shelf
On the non-VersaTools rack shelves, the MTP can be mounted in
the front or the rear of the rack.
1. Remove the feet from the bottom of the MTP if they are
already installed.
2. Mount the MTP using two 4-40 x 3/16" screws in opposite
(diagonal) corners to secure the MTP to the shelf.
3. Install false faceplate(s) or other unit(s) to the rack shelf.
4. Insert the shelf into the rack, aligning the holes in the shelf
with those of the rack.
5. Secure the shelf to the rack using the supplied machine
screws (figure 2).
98
Back of the rack mounting instructions
The MTP can be mounted to the rear of a rack using the Extron
MBB 100 VersaTools back of the rack mounting kit
(part #70-367-01) (figure 3). The kit allows the product to be
vertically mounted to the front or rear rack supports and facing
either towards the front or the rear of the rack.
MT P SERIES
Figure 3 — Attaching the back of the rack kit
1. Remove the feet from the bottom of the MTP if they are
installed.
2. Remove the two screws from one side of the unit. Retain
the screws for possible later reassembly without the
bracket.
3. Attach one bracket to the side of the unit using the longer
screws included in the kit.
4. Repeat steps 2 and 3 on the other side of the unit.