Filter
Top Products
1
USFM 100 • Installation Guide
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before starting installation.
When using this accessory, basic precautions should always be followed, including the following:
WARNING: Risk of Personal Injury. Maximum setup load for the USFM 100 (projector arm) is 20 lbs (9.1 kg).
SAVE THESE INSTRUCTIONS
NOTE: Refer to local building standards and codes to verify that the installation will meet the regulatory
requirements. Observe all local and national building and safety codes, UL requirements, and ADA
accessibility guidelines.
WARNING: Risk of Personal Injury and property damage. Do not exceed specified weight limits of any
component of the installation. Follow the manufacturer's specifications and installation instructions.
The Extron USFM 100 is a mounting kit for suspending ultra short throw projectors from a wall. The USFM 100 base
plate enclosure is capable of mounting a PoleVault
®
System switcher and its supplied power supply, with sufficient
room remaining for installing additional devices and cable management. It is designed to be used with the UPB 25
universal projector bracket (supplied with the Extron WallVault
®
system).
The USFM 100 has knockouts on all four sides that allow external raceways or conduits to be attached for cabling
runs where necessary.
Extron
USFM 100
Plastic Enclosure Cover
Boom Arm
Base Plate
Arm Cover (buttom)
Arm Cover (top)
Arm Cover (front)
Device Mounting Plate
Figure 1. USFM 100 Parts