Filter
Top Products
5
Signal Cable Access
Cutout Option
2400
V700
Raceway Option
Conduit Option
Figure 5. Cabling Run Options
If running cable behind the walls:
Run all the cables from all the locations to the USFM 100 and through the access hole (cut in step 1d).
Proceed to step 4.
If using a surface raceway or conduit:
a. Turn over the left or right cover as needed, and from the inside, cut the most suitable marked raceway or
conduit knockout for the cable to enter the USFM 100. Remove the knockout.
b. Run the raceway or conduit from all locations to the marked entrance and attach to the baseplate.
c. Run the cables through the raceway or conduit to the USFM 100.
4. Cable the Switcher
Connect the cables from the PoleVault wallplates, control device (MediaLink
®
Controller), speakers, and optional
accessories (VoiceLift, Page Sensor Kit) to the rear ports of the switcher. See the PVS 305SA Setup Guide for
connection details.
NOTE: If using a device other than a PVS 305SA (for example, PVS 204SA Plus), refer to the specific device guide
for details.
Tab