Filter
Top Products
8
NOTE!
The rack-mounting ears WILL NOT support the weight of the UPS by themselves.
They are only to be used to secure the UPS to the front rails of the rack.
Mounting rails or an equipment shelf are required to support the weight of each
UPS or battery module.
Use the following procedure to install the UPS in a rack:
1. Place the UPS on a flat, stable surface with the front of the UPS facing you.
2. Align the mounting ears with screw holes on the side of the UPS and secure with the
supplied screws.
3. If installing the Battery Module, repeat above STEPS.
4. For slide rail installations, fasten the inner parts of the slide rails to the UPS on both
sides with the screws provided.
5. ** Securing hardware and slide rails are sold separately. Contact Falcon Electric for
these additional options and any assistance needed.**
6. Attach the two mounting brackets to the rack’s mounting rails. The brackets allow
adjustment of up to eight inches of the slide assembly mounting position, front-to-
back, on the rack-mounting rails. Determine which adjustment holes to use on the
bracket, and attach it to the slide assembly on the stationary outer.