Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
4
-
1
Section 4: Setup and Installation
Procedures
The following guide will walk you through the installation of the DTC400/DTC300/DTC300M
Card Printer Driver.
• Time Requirement (software): This software installation process will require
approximately 2 to 5 minutes (depending on the speed of your PC).
• Time Requirement (Printer): The time required to set up a standard
DTC400/DTC300/DTC300M Printer would be approximately 5 to 10 minutes.
The System Requirements are as follows:
IBM-PC or compatible, Windows® 98SE, Me/2000/XP, Pentium® class 233MHz computer
with 64MB of RAM or higher, 200MB free hard disk space or higher, USB 1.1
Table of Contents
Section 4: Setup and Installation Procedures ___________________________________4-1
Table of Contents ___________________________________________________________________ 4-1
Printer Setup and Installation __________________________________________________________ 4-3
Choosing A Good Location _________________________________________________________ 4-3
About Moisture Condensation _______________________________________________________ 4-3
Printer Setup and Installation ___________________________________Error! Bookmark not defined.
Choosing A Good Location __________________________________ Error! Bookmark not defined.
About Moisture Condensation ________________________________ Error! Bookmark not defined.
Unpacking and Inspection __________________________________________________________ 4-4
Reviewing the Printer (front view)____________________________________________________ 4-4
Reviewing the Printer (front view; Cartridge being installed) _______________________________ 4-5
Reviewing the LCD (top-front part of Printer)___________________________________________ 4-5
Connecting the Printer power________________________________________________________ 4-6
Installing the Print Ribbon Cartridge __________________________________________________ 4-7
Installing the Print Ribbon Cartridge (continued) ______________________________________ 4-8
Installing the Print Ribbon Cartridge (continued) ______________________________________ 4-9
Installing Blank Cards into the Card Hopper ___________________________________________ 4-10
Installing Blank Cards into the Card Hopper (continued) _______________________________ 4-11
Installing Blank Cards into the Card Hopper (continued) _______________________________ 4-12
Lowering the Card Output Hopper___________________________________________________ 4-13
Flipper Table Module Installation______________________________________________________ 4-14
Installing the Flipper Table Module Assembly (D900200) ________________________________ 4-14
Installing the Flipper Table Module Assembly (D900200) (continued) ____________________ 4-15
Installing the Flipper Table Module Assembly (D900200) (continued) ____________________ 4-16
DTC400 Card Printer/Encoder Card Flipper Module Upgrade Kit_____________________________ 4-17
Introduction ____________________________________________________________________ 4-17
Installing the Card Flipper Module Upgrade Kit ________________________________________ 4-18
Installing the Card Flipper Module Upgrade Kit (continued) ____________________________ 4-19
Installing the Card Flipper Module Upgrade Kit (continued) ____________________________ 4-20
Installing the Card Flipper Module Upgrade Kit (continued) ____________________________ 4-21
Installing the Card Flipper Module Upgrade Kit (continued) ____________________________ 4-22
Installing the Card Flipper Module Upgrade Kit (continued) ____________________________ 4-23
Installing the Card Flipper Module Upgrade Kit (continued) ____________________________ 4-24
Installing the Card Flipper Module Upgrade Kit (continued) ____________________________ 4-25
Printer Driver Installation ____________________________________________________________ 4-26